Configuring A Microcal Itc; 200 Controller For Networking - GE MicroCal iTC200 Operating Instructions Manual

3 Installation
3.6

Configuring a MicroCal iTC

3.6 Configuring a MicroCal iTC
On a MicroCal iTC
networking and MicroCal iTC
watchdog program must be removed, and once the computer has been configured for
the local domain, two folders must be given special permissions.
Uninstallation:
1
2
3
Special Permissions:
The MicroCal iTC
folders. In order to allow a non-administrator to use this software, read/write privileges
must be set for all users for the MicroCal iTC
folders. The folder properties must allow Read & Execute, List Folder Contents, Read,
and Write, as shown below.
Figure 3-11. Configuration dialogs.
38
controller for networking
200
controller, there are several actions that must be performed for the
200
Click on the START button on the lower left side of the screen, and then on Control
Panel.
In the Control Panel window, click on Add or Remove Programs.
Find InitDTSetup in the program list. Click the Remove button by it. In the next
window, click Yes to confirm the removal.
software and Origin both need to be able to write data into their own
200
controller for networking
200
control software to work properly. First, the InitDT
200
and Origin 70 folders, including all sub-
200
MicroCal iTC Operating Instructions 28-9639-77 AA
200