Loading The Configuration; Saving The Configuration - Hirschmann RS20 Reference Manual

Basic Settings
1.6.1

Loading the configuration

In the "Load" frame, you have the option to
load a configuration saved on the device,
load a configuration stored under the specified URL,
load a configuration stored on the specified URL and save it on the
device,
load a configuration saved on the PC in binary format.
If you change the current configuration (for example, by switching a port off),
the Web-based interface changes the "load/save" symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the Web-based interface displays the "load/save" symbol as a disk again.
1.6.2

Saving the Configuration

In the "Save" frame, you have the option to
save the current configuration on the device,
save the current configuration in binary form in a file under the specified
URL,
save the current configuration in binary form on the PC,
Note: The loading process started by DHCP/BOOTP (see
page 21) shows the selection of "from URL & save local" in the "Load" frame.
If you get an error message when saving a configuration, this could be due
to an active loading process. DHCP/BOOTP only finishes a loading process
when a valid configuration has been loaded. If DHCP/BOOTP does not find
a valid configuration, finish the loading process by loading the local
configuration in the "Load" frame.
RM Web L2E
Release 6.0 07/2010
1.6 Loading/Saving the Configuration
"Network" on
31