Network - Hirschmann RS20 Reference Manual

Basic Settings

1.2 Network

With the Basic settings:Network dialog you define the source from
which the device gets its IP parameters after starting, and you assign the IP
parameters and VLAN ID and configure the HiDiscovery access.
Figure 9: Network parameters dialog
Under "Mode", you enter where the device gets its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device
"Loading/Saving the
In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device
"Loading/Saving the
In the local mode the network parameters in the device memory are
used.
RM Web L2E
Release 6.0 07/2010
Configuration").
Configuration").
1.2 Network
(see on page 30
(see on page 30
21