Functions (Menu 2) - GE Druck PC6-IDOS User Manual

SETTING MENU - To set user specific functions. (Set Functions)
Menu 2
}
High
Low
V / mA Measure
Source
Exit
Continued on
Page 7
K0354, Iss. 1

FUNCTIONS (MENU 2)

Allow the user to set a High or Low Pressure Alarm Limit.
(by using the increase/decrease facility above which an alarm sounds.)
Voltage / Current input settings for Converted Measurement.
Zero Set Zero.
FS Set Full scale value.
Text User defined measurement text.
Root Switch measurement root function 'on' or 'off'.
Exit Reverts back to Pressure Display.
Voltage / Current output settings.
Range Sets the following values:-
Zero
FS
Exit
Convert Sets the following converted values:-
Zero
FS
Text
Exit
P to V / mA Sets Pressure to V / mA conversion factors.
Zero
FS
Exit
Setup Sets the parameters for voltage/current sourcing.
Status
Root
Step
Ramp
Status
Rate
Dwell_time
Exit
Exit
Exit Returns to Pressure Display.
Sets Zero value
Sets Full Scale value
Returns to Source sub-menu.
Sets converted Zero values.
Sets converted Full Scale values.
User defined converted text.
Returns to Source sub-menu.
Set zero values.
Set Full Scale values.
Returns to Source sub-menu.
Switches output on or off.
Switch sourcing root function 'on' or 'off'.
Set step value (%FS)
Settings for Ramp mode
Switches ramp mode on or off.
Sets the ramp rate (V or mA/Sec).
Sets the time for which the output remains at the same level.
Returns to Source sub-menu.
Returns to Source sub-menu.
Page 6