GE Druck PC6-IDOS User Manual page 43

3.1 History:
• Press the key to view the sub-menus.
ENTER
ZERO
3.1.1 Overload:
• To view the overload history move the cursor to 'overload' and
press the ENTER key. The display will show the cumulative time
ZERO
since the unit was last calibrated as in the example below:
ENTER
• Press the key to return to the 'cal menu'.
ZERO
3.1.2 Span:
• To view the last zero calibration date move the cursor to 'zero/span'
ENTER
and press the key.
ZERO
• As shown above, the last calibration date is displayed first.
ENTER
• Pressing the or
ZERO
showing the 'last span set' date.
• Pressing the or
ENTER
ZERO
range of the unit and the overload setting.
ENTER
• Press the key to finish.
ZERO
• Press the key to exit to pressure display mode.
MENU
3.1.3 PC6-IDOS Serial Number:
• To view the unit's serial number move the cursor to 'PC6S/No'
and press the ENTER key.
ZERO
K0354, Iss. 1
ENTER
or
ZERO
or ENTER
ZERO
MENU
key takes you to the next screen
key again the display shows the
3.1.4 Pressure Module Serial Number:
• To view the serial number of the selected pressure module, move
the cursor to "PM_S/No" and press the
of the sensor will be displayed on the lower line.
3.2 Language : (separate PC software utility needed - contact
supplier)
To download different languages:-
• Connect PC6-IDOS to PC via the RS232 cable.
• Scroll to 'Language' and press the
• The PC6-IDOS will display a 'DOWNLOADING' message until
language download is complete.
3.3 Units User-defined unit conversion factors and the text
associated with them:-
3.3.1 View:
• Select 'Units' using the
• Select 'View' by pressing the
The first user-defined unit will now be displayed with the text on
the upper line and the conversion factor on the bottom line.
Pressing any key will display the next user-defined unit.
3.3.2 Alter: (to modify the user-defined units)
• Select 'Alter' using the
• The text for the user-defined unit is modified first using the
ENTER
and key.
ZERO
• Press the key when finished.
MENU
• Now modify the conversion factor as above. The conversion
factor is the number of user-defined units per bar.
Repeat process if required for the second user-defined unit.
Note: To prevent confusion, it will not be possible to enter text for a
user-defined unit that is identical to a factory-set unit in the PC6-
IDOS. Additionally, the maximum value for the conversion factor
is 100,000.
ENTER key. The accuracy
ZERO
ENTER
key to select.
ZERO
ENTER
key and press the key.
ZERO
ENTER
key.
ZERO
key and press the ENTER key.
ZERO
Page 35