Em Setup Menu And Changing Parameter Values - GE Mentor EM User Manual

User's Manual
EM Setup Menu and Changing
Parameter Values
The EM Setup menu provides access to those parameters that impact test conditions.
A description of each parameter is found in the Appendix. Each workflow's architect
determines which parameters are viewable and adjustable. Refer to the next several
pages of this manual to access the Display and Gates menus.
04/03/2014
Copyright by GE Sensing & Inspection Technologies 50 Industrial Park Road Lewistown, PA 17044
Mentor EM Portable Equipment
1
– The EM Setup Icon opens and closes menu
2
– Drag this list to access all parameters available
for viewing or (if enabled) modification.
3
– Touch the desired parameter control to activate
it and (if enabled) set its value.
4
– Press to increase or decrease parameter
value (if adjustable) or touch and drag for coarse
adjustment.
5
– Link icon indicates two parameters will be
adjusted in equal increments. Touch icon to unlink
or re-establish this connection.
6
– When link icon is unlinked, each parameter can
be adjusted independently. Hold icon for 2 seconds
to equalize values.
7
– Individual parameter controls may also appear
anywhere on a workflow panel.
8
– Press anywhere in this header area to
deactivate the parameter.
9
– Indicates that the parameter value is Locked.
Parameter's are locked for one of the reasons:
either the workflow's architect intended the value
to be observed but not altered, or the display is
frozen. When frozen, all parameters whose value
affects only live data are locked until the display is
unfrozen and live data returns.
10
– Units related to frequency (Hz, kHz, and MHz)
are shown in red for purposes of clarity only.
3-5