GE Druck PC6-IDOS User Manual page 24

To output voltage or current:
• Select 'Source' using the
Three options become available; 'Actual', 'Convert' and 'P
V' / mA.
• 'Actual' is selected by pressing the
An example display below shows the Source Mode symbol on
the second line.
• Select 'Converted' using the
ENTER
the key. To set the converted parameters refer to
ZERO
section 2.2.1 on page 23.
• Select 'P V' /mA using the
key. To set the parameters for this Pressure to Volts /
ENTER
ZERO
milliamps conversion refer to section 2.2.3 on page 23.
Note: An external pressure source is required.
• By pressing and holding the
seconds whilst in 'Source Mode' you will activate a '
function allowing the source value to be increased or
decreased, the longer you hold down the
the larger the nudge increments will be (see Page 25 for
more information).
K0354, Iss. 1
key and press the
ENTER
ZERO
ENTER
key.
ZERO
key and then pressing
key and then press the
key for more than two
MENU
Nudge
or key,
key.
By pressing and holding the
two seconds, the nudge function will be cancelled.
'
Note: NOT Available in Ramp or
P-V / P-mA modes
key again for more than
MENU
Page 16