Table of Contents
Advertisement
2.2.4 Setup:
Sets the parameters for V / mA sourcing
2.2.4.1 Status:
• Select 'Status' using the
• Select 'Off' or 'On' and press the
2.2.4.2 Root:
When switched on, this provides a voltage or current output with
the application of square root function.
• Select 'Root' using the
• Switch the function 'Off' or 'On' using the
2.2.4.3 Step: (Not available in P to V / mA mode)
To set the voltage or current output increments (%FS):
•
Select 'Step' with the
•
Change the value as required using the
2.2.4.4 Ramp:
(Explained on Page 25.)
To set the 'Status', Rate' and 'Dwell_time' proceed as follows:-
2.2.4.4.1 Status
•
Select 'Status' by pressing the
•
Select 'Off' or 'On' using the
2.2.4.4.2 Rate
•
Select 'Rate' with the
•
Change the V/sec or mA/sec value using the
and press the
ENTER
key.
ZERO
K0354, Iss. 1
key and press the
ENTER
ZERO
key.
ENTER
ZERO
key and press the
key.
ENTER
ZERO
and
ENTER
key and press the
key.
ENTER
ZERO
and
ENTER
ZERO
ENTER
key.
ZERO
ENTER
key and press the
ZERO
key and press the
ENTER
key.
ZERO
2.2.4.4.3 Dwell_Time
•
Select 'Dwell_time with the
•
Change the time if necessary using the
keys..
key.
key.
ZERO
key.
key
keys
key and press the
ENTER
key.
ZERO
and
ENTER
ZERO
Page
24
- Quick Links:
- Specifications Maintenance
Hide quick links:
Advertisement
Table of Contents
