DVG7 Digital Video Generator module remote commands
MASS MEMORY commands
OUTPUT commands
Command tree
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual
DVG7 Digital Video Generator module remote commands
This section describes the remote commands used to control the DVG7 Digital
Video Generator module remotely. The commands to the module are divided
into the following three groups:
MASS MEMORY commands (Refer to the TG8000 Multiformat Test Signal
Generator User Manual)
OUTPUT commands
SENSE commands
Two MASS MEMORY commands are listed here for your reference. You can
use these to load and query the output test signal. Detailed information for using
these commands are located in the TG8000 Multiformat Test Signal Generator
User Manual.
:MMEMory:LOAD:SIGNal <module_name>,<signal_name>
:MMEMory:LOAD:SIGNal <slot_number>,<signal_name>
Loads a signal into the specified module.
:MMEMory:SIGNal:ACTive <slot_number>|<module_name>
Returns the current output signal of the specified module.
Use these commands to control the output parameters of the module. These
include embedded audio and circle/text/logo overlay.
:OUTPut<n>
:CIRCle
:STATe
:DIAMeter
:POSition
:HORizontal
:VERTical
:EAUDio
:CHANnel<n>
:AMPLitude
ON | OFF
<numeric_value>
<numeric_value>
<numeric_value>
<numeric_value>
65