Sense Commands; Table 4: Gps7 Output Horizontal Offset Ranges - Tektronix TG8000 Programmer's Manual

SENSE commands

Command tree
Command description
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual
GPS7 GPS Synchronization and Timecode module remote commands
Use these commands to adjust the timing offset of the BLACK outputs relative
to the internal reference signal (frame reset signal).
:SENSe<n>
:CORRection
:MDELay
:HORizontal
:STEP
:STEP
:FINe
:FINe
:VERTical
:STEP
:SENSe<n>:CORRection:MDELay:HORizontal <numeric_value>
Sets the horizontal timing offset of the selected outputs. The timing resolution
is clock-cycles. The units are microseconds. If the argument exceeds the
horizontal time value, then the vertical offset is adjusted to accommodate the
requested delay. The <n> in the command represents the output connector. "1"
represents the BLACK1 connector, "2" represents the BLACK2 connector,
and "3" represents the BLACK3 connector. See Table 2-4 for the delay ranges.

Table 4: GPS7 output horizontal offset ranges

Standard / Frame rate
NTSC
PAL
1080 60i
1080 59.94i
1080 50i
1080 24sF
1080 23.98sF
1080 30p
1080 29.97p
1080 25p
1080 24p
1080 23.98p
1|2|3
<numeric_value> floating
point
<numeric_value>
<numeric value>
<numeric_value>
<numeric_value>
Range (sample clock cycles)
± 3432 (54 MHz clock)
± 3456 (54 MHz clock)
± 2200 (74.25 MHz clock)
± 2200 (74.18 MHz clock)
± 2640 (74.25 MHz clock)
± 2750 (74.25 MHz clock)
± 2750 (74.18 MHz clock)
± 2200 (74.25 MHz clock)
± 2200 (74.18 MHz clock)
± 2640 (74.25 MHz clock)
± 2750 (74.25 MHz clock)
± 2750 (74.18 MHz clock)
95