Avaya 4000 Series Troubleshooting Instructions page 45

Stack master image
and diagnostic
version
The following logs are provided on the unit transferring the image:
Informational: DAUR - Info: Send request for new diag image
•
– message logged after a stand-alone unit sends a DAUR request
Informational: DAUR - Info: Start receive image
•
– message logged after the unit starts to receive an image
Serious: DAUR - Warning: Diag image check sum ERROR
•
– message logged after the checksum for the receive image is not the same as the
master's checksum
Informational: DAUR - Info: Diag transfer finished
•
– message logged after the image is properly transferred and programmed to flash.
Serious: AAUR - Warning: unsupported image size. Please update image manually
•
– message logged after the slave AAUR could not support images greater than 6M.
The following logs are provided on the unit receiving the image:
Informational: DAUR - Info: Receive request for diag image. Unable to start
•
transfer
– message logged after a unit receives a request for DAUR transfer and it does not start
transfer. The possible causes are that the AAUR feature is disabled, that the diagnostic
image of the receiving unit is different from the diagnostic image of this unit, or the
message was received by a stand-alone unit (which does not have the base unit switch
selected).
Informational: DAUR - Info: Receive request for diag image, start transfer
•
– message logged after a unit receives a request for DAUR transfer and it starts
transfer.
Informational: DAUR - Info: Diag transfer finished
•
– message logged after the image is properly transferred.
Informational: DAUR - Info: Slave refuse transfer
•
Troubleshooting Avaya ERS 4000 Series
Slave image
diagnostic
version
Software 5.2_non Because the diagnostic and agent images are
SSH/SSH different, DAUR upgrades the diagnostic
Diagnostic 5.1 image, and then AAUR transfers the agent.
AAUR and DAUR reboot the unit. The unit joins
the stack after the reboot.
Software 5.2_non AAUR performs the agent image transfer and
SSH/SSH reboots the unit. The unit joins the stack after
Diagnostic 5.2 the reboot.
Diagnostic Auto Unit Replacement (DAUR)
Expected behavior
April 2014 45