Configuring Snmpv3 Trap Receiver - Avaya 4000 Series Troubleshooting Instructions

Troubleshooting RSTP SNMP traps
Procedure
1. Use the snmp-server community notify-view acli command to configure
2. When prompted, enter and confirm the community string.
3. Use the snmp-server host <IP address> v2c <string> command to
Variable Definitions
IP address
string

Configuring SNMPv3 trap receiver

About this task
Use the procedure in this section to configure an SNMPv3 trap receiver.
Procedure
1. Use the snmp-server user trapuser notify-view acli command to
2. Use the snmp-server host <IP address> v3 no-auth <user> command
Variable Definitions
IP address
user
214 Troubleshooting Avaya ERS 4000 Series
the community string.
configure the community string.
Variable
configure the trap user.
to configure the community string.
Variable
Comments? infodev@avaya.com
Definition
IPv4 address of the server host
The community string that has been defined
for sending SNMPv2c traps
Definition
IPv4 address of the server host
The user that has been defined for sending
SNMPv3 traps
April 2014