Checking UDP statistics
About this task
Use the procedure in this section to view the UDP statistics.
Procedure
1. Use the show ipv6 udp command to show the UDP statistics.
2. Use the show ipv6 udp endpoints command to show the UDP endpoints.
3. Observe the command output.
Checking if the application on the remote host supports UDPv6.
About this task
Use the client documentation to ensure UDPv6 is enabled on the remote host.
Cannot set IPv6 address
This taskflow assists you when you set an IPv6 address and it fails with the following reason:
Max IPv6 addresses per interface exceeded.
Cannot set IPv6 address
About this task
This task flow assists you when you set an IPv6 address and it fails with the following reason:
Max IPv6 addresses per interface exceeded.
Troubleshooting Avaya ERS 4000 Series
Cannot set IPv6 address
April 2014
187