If a new code is to be inserted it may be entered via this option, however we recommend that the
web interface is used for entering a new licence by copying and pasting, as entering an incorrect
licence may result in the unit becoming inoperable.
5.4.3.1.3.
This line displays the last fourteen characters of the unit's licence code.
If a new code is to be inserted it may be entered via this option, however we recommend that the
web interface is used for entering a new licence by copying and pasting, as entering an incorrect
licence may result in the unit becoming inoperable.
5.4.3.1.4.
This item displays whether the licence code has been accepted by the unit.
5.4.3.2.
This menu provides the facility to configure the date and time in the unit. The unit contains an
internal battery that will maintain the current time when it does not receive external power.
5.4.3.2.1.
This option allows for the time to be set in the unit.
5.4.3.2.2.
This option allows for the date to be set in the unit.
5.4.3.2.3.
This item allows for the date format to be configured to either dd/mm/yy or mm/dd/yy (where dd
represents the day, mm represents the month and yy the year).
5.4.3.2.4.
This item displays the total amount of hours that the unit has been in operation.
5.4.3.3.
5.4.3.3.1.
This option allows for the front panel LED's to be tested, which will be lit and cycled through their
colours, if applicable.
5.4.3.3.2.
This option provides the facility to adjust the contrast of the display.
Note that unlike all other options, changing this value cannot be cancelled by use of the Escape
button.
5.4.3.3.3.
This option will provides the facility to perform a fault test of the unit. Any errors or warnings
reported will be displayed on the Alarm page which is accessed via the Status button.
Issue : 3 (16/12/2015)
Ref : ULTC-ASUM-7001
Line 2
State
T
IME
Time
Date
Format
Run Hours
M
ISCELLANEOUS
Lamp Test
Contrast
Fault Test
UltraCoder Operators Manual
Menu Navigation
Page : 25
Copyright © Vislink plc
Need help?
Do you have a question about the UltraCoder and is the answer not in the manual?