Vislink UltraCoder Operator's Manual page 28

To perform the store, first ensure that a USB memory stick is inserted into the USB connector on the
front panel, then select this item for editing, change the value to Yes and press the Enter button.
The display will then change requesting confirmation of the action, at which point press Enter again
to confirm, or Escape to cancel.
5.4.1.4.
This item provides the ability to restore the unit to its factory defaults. To perform this action
change the setting to YES and then press the Enter button.
5.4.2. R
EMOTE
5.4.2.1.
This section provides the facility to configure the Ethernet settings for remote control by either
SNMP or web browser.
5.4.2.1.1.
This item defines the IPv4 Address of the unit, which will be used by external devices to connect to it
via SNMP or web browser for remote configuration.
5.4.2.1.2.
This item defines the subnet mask of the unit for remote configuration.
5.4.2.1.3.
This item defines the gateway of the unit for remote configuration.
5.4.2.1.4.
This item displays the MAC address of the unit.
5.4.2.2.
5.4.2.2.1.
This item allows for a descriptive text identifier to be defined that will be displayed on the web
interface, which is of use when working with multiple units.
5.4.3. S
ERVICE
5.4.3.1.
This section displays and allows for the insertion of new licences. Certain features in the unit will be
unavailable, or provided with limited functionality until a relevant licence is provided.
5.4.3.1.1.
This item displays the unit's electronic serial number, which should be quoted when requesting new
licences.
5.4.3.1.2.
This line displays the first fourteen characters of the unit's licence code.
Issue : 3 (16/12/2015)
Ref : ULTC-ASUM-7001
R D
ESTORE EFAULTS
I
NTERFACES
E
THERNET
IP
Mask
Gway
MAC
W I
EB DENTIFIER
ID
L
ICENCES
ESN
Line 1
UltraCoder Operators Manual
Menu Navigation
Page : 24
Copyright © Vislink plc