Vislink UltraCoder Operator's Manual page 23

Note that if a 4K video format has been selected, then only Video-1 will be editable.
5.3.2.2.2.
Select this item to view further inputs to edit.
Select whether the video received via the ASI In connector on the rear panel should be included in
the multiplexed video.
Select whether the video received via the IP Video connector on the rear panel should be included in
the multiplexed video.
5.3.2.3.
This menu is used to configure the source and format of the video output from the ASI Out
connector on the rear panel.
5.3.2.3.1.
This option provides the facility to define the video output from the ASI Out connector. Available
settings are: Off (no video output); Mux (from the video encoder after multiplexer); Video (all of the
streams input to the video encoder); ASI In (video from the physical rear panel connector); or, IP In
(de-encapsulated ASI from the IP Video connector).
5.3.2.3.2.
This option defines the size of the ASI packets output as either 188 or 204 Bytes.
5.3.2.4.
5.3.2.4.1.
This menu provides the ability to configure the service settings for multiplexing the video received
via the ASI In connector on the rear panel.
This item is used to define the name of the service to use when multiplexing the video from the ASI
In connector.
Note that the maximum amount of characters that may be entered is twelve.
This item is used to define the program number of the service to use when multiplexing the video
from the ASI In connector.
Valid values range from 1 to 65535.
This item allows for the Program Map Table PID to be defined for multiplexing the video from the
ASI In connector.
Issue : 3 (16/12/2015)
Ref : ULTC-ASUM-7001
MORE >
5.3.2.2.2.1. ASI In
5.3.2.2.2.2. IP In
ASI O
UTPUT
ASI Out
ASI Out Mode
E I PID
XTERNAL NPUT
External ASI PIDs
5.3.2.4.1.1. Service
5.3.2.4.1.2. Prog Number
5.3.2.4.1.3. PMT
S
UltraCoder Operators Manual
Menu Navigation
Page : 19
Copyright © Vislink plc