Communication - Eneo MPC-52A0030P0A User Manual

3.8 Communication

To prevent damage, each camera must have a unique address (ID).
The factory default setting is 1.
MASTER ID
SLAVE ID
TYPE
PORT
MASTER PROTOCOL
SLAVE PROTOCOL
BAUDRATE
PARITY
TERMINATION
The device which is connected at end of line, whether it is the camera or keyboard, must have
the cable for communication terminated by setting above. Without proper termination, there is
potential for control signal errors. Total length of the cable for communication should not
exceed 4000 ft (1.2 km).
ANSWER
This option is helpful to escape the collision of the command using some DVR.
• Control Method
- MASTER:
By using RS-485 or RS-422 TX serial communication port, it allows you to control the external
device (Pan & Tilt System) through CoC (Control over Coax) signal from DVR.
COMMUNICATION
MASTER ID
SLAVE ID
TYPE
PORT
MASTER PROTOCOL : PELCO-D
SLAVE PROTOCOL
BAUDRATE
PARITY
TERMINATION
ANSWER
SAVE AND EXIT(ESC TO CANCEL)
1 ~ 3999
1 ~ 3999
485: MASTER, SLAVE
422: MASTER, SLAVE, MASTER/SLAVE
485, 422
PELCO-D, PELCO-P, F2E, F2, NONE
PELCO-D, PELCO-P, F2E, F2, NONE
2400, 4800, 9600, 19200, 38400 bps
NONE, EVEN, ODD
ON, OFF
ON, OFF (no acknowledge command from the camera)
18
*
: 0001
*
: 0001
: SLAVE
: 485
: PELCO-D
: 9600
: NONE
: OFF
: OFF