Connections - Eneo MPC-52A0030P0A User Manual

2.3 Connections

• Connecting to the RS-485/422
The camera can be controlled remotely by an external device or control system, such as a
control keyboard, using RS-485 half-duplex, RS-422 full-duplex serial communications signals.
Connect Marked TX+(485+), TX-(485-) to TX+(RX+), TX-(RX-) of the RS-485 control system.
If control system is RS-422, connect TX+(485+), TX-(485-) and RX+, RX- of the camera
to RX+, RX- and TX+, TX- of the control device respectively.
• Connecting HD Output connector
Connect the HD output (BNC) connector to the video input.
• Connecting CVBS Output connector
Connect the CVBS output (BNC) connector to the video input.
• Connecting Alarms
- ALARM IN
You can use external devices to signal the camera to react on events. Mechanical or electrical
switches can be wired to the ALARM IN and GND connectors.
- GND (Ground)
Connect the ground side of the alarm input and/or alarm output to the GND connector.
- ALARM OUT (5VTTL)
The camera can activate external devices such as buzzers or lights. Connect the device to the
ALARM OUT and GND connectors.
• Connecting the Power
Connect power of 12VDC for the camera.
When using a 12VDC adapter, connect the positive (+) pole to the '+' position and
the negative (-) pole to the '-' position.
Use satisfy clause 2.5 of IEC60950-1/UL60950-1 or Certified/Listed Class 2 power source only.
8