Tour - Eneo MPC-52A0030P0A User Manual

3.5 Tour

There are 8 programmable Tours. Each Tour consists of up to 40 Preset positions, Patterns, Scans
or other Tours (second-level). Using second-level Tours, it can be expanded to over 300 functions
in a single Tour.
Follow the steps below to program the Tours:
1. Press the MENU key to display the main menu on the monitor. Scroll to Tour and press the
Right key to enter the Tour menu.
2. Select "NUMBER" and set the desired number by pressing the Right or Left key.
3. Select "TOUR FUNCTION" and press the Right key to enter the Tour Function Setup menu.
4. Choose a blank position to be programmed by pressing the Up, Down, Right or Left key.
5. To add a stored Preset, press the Tele or Wide key then the stored Preset number displays.
6. To place functions other than Preset, press the IRIS Open key to scroll for Tour.
7. You can also overwrite the programmed number and remove a stored number from the Tour,
press the IRIS Open key until '---' is displaying in the position.
8. Repeat step 2 through 6 for each desired position. Each title will be displayed on top of the line.
9. To edit the "TITLE", follow the procedure of the Preset above to edit titles.
10. Select "SAVE AND EXIT" and press the Right or IRIS Open key. Press the IRIS Close key to
exit the program without saving.
TOUR SETUP
NUMBER
TITLE
TOUR FUNCTION
SAVE AND EXIT(ESC TO CANCEL)
TOUR FUNCTION SETUP
DWELL
003 --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- T02 --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
EXIT(ESC TO EXIT)
---
003
T02
: 01
: T01
(CTRL KEY)
: -- SEC
Blank position
Preset (1 ~ 240)
Tour (1 ~ 8)
13