Operating Procedures; General Instructions - HWH 625 SERIES Operator's Manual

Maintain adequate clearance in all directions for vehicle, room
extensions, awnings, doors, steps, etc. Vehicle may move in
any direction due to jacks extending or retracting, settling of
the jacks or the vehicle, equipment malfunction, etc..
If parking on soft ground or asphalt paving, a wood block or
pad should be placed under each jack.
Press the "OFF" button or turn the ignition switch "OFF" at
any time to stop the operation of the system.
Any time a hydraulic leveling process is interrupted, retract
the jacks according to the JACK RETRACTION Section and
then restart the leveling process.
Before traveling, the red jack warning lights must be off
and the "TRAVEL MODE" light must be on. If lights are
not correct for travel, retract jack as described in the
JACK RETRACTION Section.
If the jacks are retracted but a red "WARNING" light is lit
or the green "TRAVEL MODE" light is not lit, the system
needs to be serviced.
Any room extension or generator slide should be fully
retracted before traveling.
CAUTION:
DO NOT MOVE THE VEHICLE WHILE
THE LEVELING JACKS ARE STILL IN CONTACT WITH
THE GROUND OR IN THE EXTEND POSITION. THIS
VEHICLE IS EQUIPPED WITH STRAIGHT-ACTING JACKS.
MOVING THE VEHICLE WITH THE LEVELING JACKS
EXTENDED CAN CAUSE SEVER DAMAGE TO THE JACKS

OPERATING PROCEDURES

GENERAL INSTRUCTIONS

PREPARATION FOR TRAVEL
If the hand / auto brake is not set when the "HYD" button
is pressed, the "NOT IN PARK/BRAKE" light will come on.
When the "HYD" button is released the "NOT IN PARK/
BRAKE" light will go out. The panel will NOT turn on.
CAUTION:
DO NOT MOVE THE VEHICLE IF ONE
OR MORE JACKS ARE EXTENDED TO THE GROUND.
AND OR THE VEHICLE AND CREATE A DRIVING
HAZARD. DO NOT RELY SOLELY UPON WARNING
LIGHTS. IT IS THE OPERATOR'S RESPONSIBILITY
TO CHECK THAT ALL JACKS ARE FULLY RETRACTED
INTO THE STORE/TRAVEL POSITION AND THE
VEHICLE IS AT THE PROPER RIDE HEIGHT FOR
TRAVELING. CONTACT MANUFACTURER TECHNICAL
SERVICE BEFORE MOVING A VEHICLE THAT IS NOT
AT PROPER TRAVEL HEIGHT.
IMPORTANT: Any time the "HYD" button has been
pushed, push the "STORE" button before traveling.
If the jacks cannot be retracted according to the JACK
RETRACTION Section, retract the jacks according to the
MANUAL JACK RETRACTION Section. The system
should then be checked.
MP35.3811
19NOV07