HWH 625 SERIES Operator's Manual page 14

ROOM RETRACT PROCEDURE FOR ROOMS WITHOUT TRAVEL CLAMPS
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
NOTE: It is recommended to retract room extensions
before retracting jacks.
1. The park brake must be set. The room will not operate
if the park brake is not set.
2. Turn the ignition switch to ACCESSORY.
3. Turn the room control panel KEY SWITCH to
the "ON" position.
4. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted.
NOTE: Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
pressurization of the cylinders.
of the room, do not reverse direction of the room until
the room is fully retracted. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT retract the room until the room
has been fully extended.
OPERATING PROCEDURES
During normal operation
IMPORTANT: Do not hold the ROOM CONTROL SWITCH
in the "RETRACT" position for more than ten seconds
after the room is fully retracted or stops moving.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
NOTE: Releasing the ROOM CONTROL SWITCH will
halt the operation of the room.
5. Turn the room contol panel KEY SWITCH to
the "OFF" position.
6. Turn the ignition switch off.
7. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
IMPORTANT: Room-locking devices should be locked
while traveling.
MP35.3880
23JUL03