HWH 625 SERIES Operator's Manual page 15

GENERATOR SLIDE EXTEND PROCEDURE
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF SLIDE WHEN OPERATING.
NOTE:Make sure there is adequate clearance to fully extend
the slide.
1. Turn the ignition key on.
2. THE PARK BRAKE MUST BE SET FOR THE SLIDE TO
OPERATE.
GENERATOR SLIDE RETRACT PROCEDURE
1. Turn the ignition key on.
2. THE PARK BRAKE MUST BE SET FOR THE SLIDE TO
OPERATE.
3. To retract the slide, press and hold the GENERATOR SLIDE
CONTROL SWITCH in the "RETRACT" position. When the
slide is fully retracted, release the GENERATOR SLIDE CON-
TROL SWITCH.
OPERATING PROCEDURES
3. To extend the slide, press and hold the GENERATOR SLIDE
CONTROL SWITCH in the "EXTEND" position. When the
slide is fully extended, release the GENERATOR SLIDE CON-
TROL SWITCH.
IMPORTANT: Do not hold the GENERATOR SLIDE CONTROL
SWITCH in the "EXTEND" position for more than ten seconds
after the slide is fully extended or stops moving.
NOTE: Releasing the GENERATOR SLIDE CONTROL SWITCH
will halt the operation of the slide.
IMPORTANT:
SWITCH in the "RETRACT" position for more than ten seconds
after the slide is fully retracted or stops moving.
NOTE:
will halt the operation of the slide.
IN THE EVENT OF FAILURE OF THE GENERATOR SLIDE
TO RETRACT, CONTACT HWH CORPORATION CUSTOM-
ER SERVICE AT 1-319-724-3396 OR 1-800-321-3494 FOR
ASSISTANCE.
Do not hold the GENERATOR SLIDE CONTROL
Releasing the GENERATOR SLIDE CONTROL SWITCH
MP35.4724
28JUL98