Download Print this page

HWH 625 SERIES Operator's Manual page 12

Computer-controlled leveling system and spacemaker room extension systems
Hide thumbs Also See for 625 SERIES:

Advertisement

ROOM RETRACT PROCEDURE FOR ROOMS WITH TRAVEL CLAMPS
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
NOTE: It is recommended to retract room extensions
before retracting jacks.
1. The park brake must be set. The room will not operate
if the park brake is not set.
2. Turn the ignition switch to ACCESSORY.
3. Turn the room control panel KEY SWITCH
to the "ON" position.
4. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted and both Travel Clamps
Engaged light come on.
IMPORTANT: When the room is fully retracted, a room
in limit switch will allow the Travel Clamps to extend.
The hydraulic pump will run for approximately 5 seconds
after the room is fully retracted. It will take the Travel
Clamps approximately 20 seconds to extend after the
room is fully retracted. When the Travel Clamps are fully
extended, the 2 Travel Clamps Engaged lights will come
on. When both Travel Clamps Engaged lights are on, the
room control switch should be released. If the Travel
Clamps Engaged lights do not come on, DO NOT hold
the room control switch to RETRACT for longer than
40 seconds after the room extension is fully retracted.
OPERATING PROCEDURES
NOTE: During normal operation of the room, do not
reverse direction of the room until the room is fully
retracted. If necessary, the direction of the room may
be reversed, but watch for binding of the room. If the
direction of the room has been reversed, DO NOT
retract the room until the room has been fully extended.
IMPORTANT: If either side of the room stops moving,
release the room control switch immediately. DO NOT
force the room. DO NOT reverse direction of the room,
contact HWH Customer Service for assistance
1-800-321-3494.
NOTE: Releasing the ROOM CONTROL SWITCH will
halt the operation of the room.
5. Turn the room panel KEY SWITCH to the "OFF" position.
6. Turn the ignition switch off.
7. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
IMPORTANT: Room-locking devices should be locked
while traveling.
MP35.3860
23JUL03

Advertisement

loading