HWH 625 SERIES Operator's Manual page 13

ROOM EXTEND PROCEDURE FOR ROOMS WITHOUT TRAVEL CLAMPS
CAUTION:
OPERATING A ROOM WITH ANY
ROOM LOCKING, CLAMPING OR MANUAL RETRACTING
DEVICES ATTACHED OR ENGAGED CAN CAUSE
PERSONAL INJURY AND VEHICLE DAMAGE. IT IS THE
OPERATOR'S RESPONSIBILITY TO ENSURE THAT
ALL ROOM LOCKING, CLAMPING OR MANUAL
RETRACTING DEVICES ARE DETACHED OR
DISENGAGED BEFORE OPERATING THE ROOM.
NOTE: It is recommended to complete the Leveling
Procedure before operating room extensions. It is
recommended to retract room extensions before
retracting jacks.
1. The park brake must be set. The room will not
operate if the park brake is not set.
2. Follow the LEVELING AND STABILIZING PROCEDURE.
3. Unlock all room-locking devices.
NOTE: If the MANUAL RETRACT WINCH is attached to
the room remove it before extending the room.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
NOTE: Make sure there is adequate clearance to fully
extend the room.
4. Turn the ignition switch to ACCESSORY.
5. Turn the room control panel KEY SWITCH to
the "ON" position.
OPERATING PROCEDURES
6. To extend the room, press and hold the
ROOM CONTROL SWITCH in the "EXTEND" position
until the room is fully extended.
NOTE:
after the room is fully extended. This assures proper
pressurization of the cylinders.
of the room, do not reverse direction of the room until
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
has been fully retracted.
IMPORTANT:
in the "EXTEND" position for more than ten seconds
after the room is fully extended or stops moving.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
NOTE: Releasing the ROOM CONTROL SWITCH will
halt the operation of the room.
7. Turn the room control panel KEY SWITCH to
the "OFF" position.
8. Turn off the ignition switch.
IMPORTANT: Do not use a room extension support
when the vehicle is supported by the leveling system.
Hold the switch to "EXTEND" three or four seconds
During normal operation
Do not hold the ROOM CONTROL SWITCH
MP35.3870
23JUL03