Table of Contents
Advertisement
4. SETUP AND PREPARATION BEFORE OPERATION
Point
(1) Set the offset and gain values in the actual usage state.
(2) The offset and gain values are stored in the AJ65BT-64DAV/DAI, and are not erased even
the power supply is shut off.
(3) Perform the offset/gain setting when the PLC CPU is stopped.
conversion is stopped for all channels, so use the remote READY signals as an interlock.
(4) Perform the offset/gain setting in the range from DC -10 to +10V or from 4 to +20mA.
When the setting exceeds this range, the maximum resolution or total precision may not be in
the range indicated in the performance specification.
4.4
Station Number Setting
By the AJ65BT-64DAV/DAI station number setting, the addresses to store the control I/O signal data
and read/write data are determined.
For details, refer to the user's manual of the master module used.
4.5
Facing Direction of the Module Installation
When the module is installed next to the panel
Panel
4-5
When in the test mode, D/A
When the module is installed on the panel
MELSEC-A
Advertisement
Table of Contents
