Table of Contents
Advertisement
6
6.1
If switch "RFR" is closed, the controller is enabled.
If the switch "controller enable" (RFR) is open the speed controller
is inhibited, i.e. the firing pulses are set to the inverter limit position.
Only use low-current contacts for the switching of signal cables
(15V / 1.5mA)
6.2
The function "RSP", i.e. the inhibiting of the controller with a
normally-open contact is possible using the following connection.
When "RSP" (controller inhibit) is closed, the firing pulses are set to
the inverter limit position.
Only use low-current contacts for the switching of signal cables
(15V / 1.5mA)
26
Switching operation
Controller enable
16 17
RFR
Controller inhibit
7
16 17
RSP
L
Hide quick links:
Advertisement
Table of Contents
