Manitowoc Grove RT9130E Product Manual page 24

Load chart
Installation and removal of counterweight and auxiliary hoist rated lifting capacities in pounds
Radius in feet
Installation and removal of front and rear outrigger boxes rated lifting capacities in pounds without counterweight
Radius in feet
• Capacities are applicable to machines equipped with Titan 33.25 x 29 (38 ply) tires at 85 psi cold inflation pressure
Capacities do not exceed % of tipping loads as determined by test in accordance with SAE J
• With no load, the boom angle must not be less than 35˚ when over sides of machine since loss of stability will occur
causing a tipping condition. To lower boom below 35˚ boom angle, boom must be swung over front or rear and LMI
bypass activated.
• Once one outrigger box is installed, do not swing load over that end of the machine while installing the other outrigger
box.
• Each outrigger box assembly weighs 9373 lb including the outrigger beams and pads.
• May be used for single or double line lifting service.
THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane's load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane.
On outriggers fully extended
On rubber stationary
* The boom must be fully retracted.
Notes for on rubber
°
Main boom length ft*
,
,
,
,
,
,
°
Main boom length ft*
,
,
,
,
.