Manitowoc Grove RT9130E Product Manual page 20

Load chart
ft ft luffing folding boom extension fixed angle
ft
ft ft ,
ft LENGTH
° ° °
Feet OFFSET OFFSET OFFSET
��,���
��
���.��
��,���
��
����
��,��� ��,���
��
���.�� ���.��
��,��� ��,��� *��,���
��
���� ���� ����
��,��� ��,��� ��,���
��
���.�� ���.�� ����
��,��� ��,��� ��,���
��
���� ���� ���.��
��,��� ��,��� ��,���
��
���� ���� ����
��,��� ��,��� ��,���
��
���.�� ���.�� ����
��,��� ��,��� ��,���
��
���� ���� ���.��
��,��� ��,��� ��,���
��
���� ���� ���.��
��,��� ��,��� ��,���
���
���.�� ���.�� ����
���� ���� ��,���
���
���.�� ���.�� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ����
���� ���� ����
���
���� ���� ���.��
���� ���� ����
���
���.�� ���.�� ����
���� ���� ����
���
���.�� ���� ���.��
���� ����
���
���.�� ���.��
���� ����
���
���� ���.��
���� ����
���
���� ����
���� ����
���
���� ���.��
���
���
���
Min. boom
angle for
° ° °
�� �� ��
indicated
length �no load�
Max. boom
length �ft� at
��� ft
�° boom angle
�no load�
NOTE: � � Boom angles are in degrees.
�LMI operating code. Refer to LMI manual for operating
instructions.
*This capacity is based on maximum obtainable boom angle.
THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane's load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane.
lb % °
ft in
spread
Pounds
ft LENGTH
° ° °
OFFSET OFFSET OFFSET
����
����
����
����
���� ����
���.�� ����
���� ����
���� ���.��
���� ����
���.�� ����
���� ���� ����
���� ���.�� ����
���� ���� ����
���.�� ���� ���.��
���� ���� ����
���.�� ���� ���.��
���� ���� ����
���� ���� ����
���� ���� ����
���� ���.�� ���.��
���� ���� ����
���.�� ���� ����
���� ���� ����
���� ���.�� ���.��
���� ���� ����
���.�� ���� ���.��
���� ���� ����
���� ���.�� ����
���� ���� ����
���.�� ���.�� ����
���� ���� ����
���.�� ���� ���.��
���� ���� ����
���� ���� ���.��
���� ���� ����
���� ���.�� ���.��
���� ���� ����
���� ���.�� ���.��
���� ���� ����
���� ���.�� ���.��
���� ���� ����
���� ���.�� ����
���� ���� ����
���� ���.�� ����
���� ���� ����
���� ���� ���.��
���� ����
���.�� ����
���� ����
���.�� ����
����
���.��
° ° °
�� �� ��
��� ft
A������������
ft main boom
NOTES:
. All capacities above the bold line are based on
structural strength of boom extension and do not
exceed % of tipping loads, in accordance with
SAE J .
. ft boom extension may be used for single or
double line lifting service.
may be used for single line lifting service only.
WARNING: Lifting with the
with the ft extension fly either erected or folded
along side of extension base, is strictly prohibited.
. Radii listed are for a
extension erected. For main boom lengths less
than ft, the rated loads are determined
by boom angle. Use only the column which
corresponds to the boom extension length and
offset for which the machine is configured. For
boom angles not shown, use the rating of the next
lower boom angle.
WARNING: Operation of this machine with
heavier loads than the capacities listed is strictly
prohibited. Machine tipping with boom extension
occurs rapidly and without advance warning.
. Boom angle is the angle above or below horizontal
of the longitudinal axis of the boom base section
after lifting rated load.
. Capacities listed are with outriggers properly
extended and vertical jacks set only.
ft boom extension
ft extension base,
ft boom with the boom