Table of Contents
Advertisement
IPLink 2800 Series Getting Started Guide
tion
"Configuring T1/E1
mode is immediately entered. To remove an existing channel-group the 'no' form of the command has to
be used.
Mode: port e1t1 <slot> <port>
Step
[ name ] (prt-e1t1)[slot/port]#[no] channel-
1
group group-name
Configuring Channel-Group Timeslots
The 'timeslots' command configures an arbitrary sequence of timeslots for use in data transmission. The syntax
of the command accepts comma-separated groups of timeslots. A group can be a single timeslot or a range of
timeslots. The channel-group timeslots do not have to be contiguous. The 'no' form of the command releases
all previously selected timeslots.
Example:
>timeslots 1,4,6
>timeslots 1,4-6
>timeslots 1-3,4-6
Mode: channel-group group-name
Step
1
[name] (ch-grp)[group-name]#[no]
timeslots timeslots
Configuring Channel-Group Encapsulation
In the channel-group configuration mode only the encapsulation type 'hdlc' is available. For more details see ,
"Configuring T1/E1 encapsulation"
Mode: channel-group group-name
Step
1
[name] (ch-grp)[group-name]#[no] encap-
sulation hdlc
Entering HDLC Configuration Mode
The hdlc configuration mode can be entered either from the "port T1/E1" configuration mode or from the
"channel-group" configuration mode. If you cannot enter the hdlc mode, it may be due to an invalid or incom-
plete configuration, and an error message will be issued. In "port T1/E1" configuration mode, you only need to
set the encapsulation for 'hdlc' in order to enter the hdlc configuration mode. In "channel-group" configura-
T1/E1 port configuration task list
encapsulation".) On creating a new channel-group the channel-group configuration
Command
Selects three timeslots (1, 4 an 6)
Selects four timeslots (1, 4, 5 and 6)
Selects six timeslots (1, 2, 3, 4, 5 and 6)
Command
on page 64.
Command
5 • T1/E1 port configuration
Purpose
Enters the channel-group configuration mode of
group-name . If the group does not yet exist a new
one will be created. The 'no' form of the command
removes an existing channel-group.
Purpose
Selects the timeslots to be used.
Default: no timeslots
Purpose
Specifies the encapsulation type of the channel-
group. Default: no encapsulation
65
Advertisement
Table of Contents
