Table of Contents
Advertisement
TID (show the serial number)
[Format]
TID
[Response]
xxxxxxxxx:
9-digit serial number
N0:
Command error
[Function]
The FDP02 replies its 9 digits serial number when this command is executed.
If it is failed to read the serial number, the FDP02 returns "?".
[Example of use]
>@TID<Cr><Lf>:
< xxxxxxxxx <Cr><Lf>:
TS2 (executing a communication line quality test)
[Format]
TS2
[Response]
P0:
Command accepted
Connect:
Line connected and line quality test is started
ooooo....ooxo 003: Test result
Disconnect:
Line disconnected
N0:
Command error
[Function]
-
The communication line quality test is executed by this command. At the test, one data packet has 32
bytes and one hundred packets are exchanged as a test unit between the "master" FDP02 and the
"slave" FDP02. The test results are output to the serial port.
-
The test result is shown by "o" and "x" for each packet. "o" indicates that it is no communication
error and "x" indicates that communication error is occurred.
-
When this command is executed at the "master" FDP02, the "master" tries to connect the "slave"
FDP02 that wireless address is defined by REG02 of the "master". At that time, operation mode of the
"slave" is automatically changed to TS2 communication line quality test mode.
-
Both the "master" and the "slave" output the test result.
-
Total error occurrence of the test is indicated in 3 digits number after 100 of "o" "x" judgments.
-
If consecutive 1,000 packets become communication error, the line is disconnected. After the
disconnection, the "master" continues to request wireless connection but the "slave" abort from TS2 test
mode.
-
During this TS2 test mode, all the commands except for "FUN", "FRQ" and "RST" command are do
not work. For abort from TS2 test mode, it is needed to execute "RST" command or turned off the
main power of the FDP02. When the "master" aborts from TS2 test mode, the "slave" automatically
stops the test mode and returns to normal operation mode.
[Example of use]
>@TS2<Cr><Lf>:
<P0<Cr><Lf>:
<Connect<Cr><Lf>:
<xooooooooo...ooox 003<Cr><Lf>: This response indicates the test result and 3 packets became
<oooxoooooo...oxoo 002<Cr><Lf>: This response indicates the test result and 2packets became
<oooooooxxo...ooxo 004<Cr><Lf>: This response indicates the test result and 4 packets became
<ooxxxooooo...oxoo 006<Cr><Lf>: This response indicates the test result and 6 packets became
This command requests to show the serial number of the FDP02.
This response indicates the serial number of the FDP02.
The FDP02 runs communication test by this command.
This response indicates that the command is accepted.
This response indicates that the line is connected.
communication errors during 100 packet correspondences.
communication errors during 100 packet correspondences.
communication errors during 100 packet correspondences.
communication errors during 100 packet correspondences.
41
Ver.1.1
Advertisement
Table of Contents
