FUTABA FDP02TJ010 Instruction Manual page 50

Ver.1.1
PTS (
Show/Set sleep time
[Format]
PTS(:setting value)
Available setting value: 001 to 255
[Response]
xxx: Current setting value (as referring the value)
P0: Normal end (as setting the value)
N0: Co mmand error
[Function]
- This command can refer and/or set the time duration of the sleep time. The sleep time duration is the
setting value of this command times 10ms if the setting of bit 1 of RGE24 is "0". Also, it is the setting
value of this command times 100ms if the setting of bit 1 of RGE24 is "1". For example, if the setting
value is 030 and the setting of bit 1 of REG24 is "0", the sleep time duration is 30ms (030 x 10ms). If
the setting value is 050 and the setting of bit 1 of REG24 is "1", the sleep time duration is 500ms (050 x
100ms).
[Example of use]
>@PTS<Cr><Lf>:
<025<Cr>Lf>:
>@PTS010<Cr><Lf>:
<P0<Cr><Lf> :
ROF (
)
RF circuit OFF
[Format]
ROF
[Response]
P0: Norm al end
N0: Co mmand error
[Function]
- This command turns off the RF circuit. If the RF circuit has been already turned off, N0 response is
returned after executing this command.
[Example of use]
>@ROF<Cr><Lf>:
<P0<Cr><Lf> :
)
Show current setting value
The setting value is 025. It means that sleep time is 250ms (as bit 1 of REG24
is "0") or 2500ms (as bit 1 of REG24 is "1").
Set the sleep time duration to 100ms (as bit 1 of REG24 is "0") or 1000ms (as bit
1 of REG24 is "1").
Normal end.
Turn off the RF circuit.
Normal end.
During the RF circuit is turned off, @TXT and @TBN command are not
available.
38