Serial-Output Data Format Of Receiver Side At The Transmission Mode - FUTABA FDP02TJ010 Instruction Manual

Ver.1.1

2.3 Serial-Output Data Format of Receiver Side at The Transmission Mode

Data format of the receiver side that outputs to the serial port varies depending on the transmission mode
(packet transmission or headerless packet transmission mode). The below table shows combination of the
data format and the mode setting.
Sender FDP02 (radio address is 000)
Transmission mode
Packet transmission (text
format)
Packet transmission
(binary format)
Packet transmission (text
format)
Packet transmission
(binary format)
Headerless packet
transmission + <Cr><Lf>
Headerless packet
transmission + time-out
Headerless packet
transmission + <Cr><Lf>
Headerless packet
transmission + time-out
* If "Adding '<Cr><Lf>' to received data" function of the receiver FDP02 is turned on by the bit 4 of REG23
(setting value is 1) at the headerless transmission mode, "<Cr><Lf>" is added at the end of the data that is
output to serial port.
Packet format
@TXT001HELLO<Cr><Lf>
@TBN001005HELLO<Cr>
<Lf>
@TXT001HELLO<Cr><Lf>
@TBN001005HELLO<Cr>
<Lf>
HELLO<Cr><Lf>
HELLO
HELLO<Cr><Lf>
HELLO
Receiver FDP02 (radio address is 001)
Transmission mode
Packet transmission
Packet transmission
Headerless*
Headerless*
Packet transmission
Packet transmission
Headerless*
Headerless*
4
Serial-output data format
RXT000HELLO<Cr><Lf>
RBN000005HELLO<Cr><Lf>
HELLO
HELLO
RBN000007HELLO<Cr><Lf>
<Cr><Lf>
RBN000005HELLO<Cr><Lf>
HELLO<Cr><Lf>
HELLO