FUTABA FDP02TJ010 Instruction Manual page 30

Ver.1.1
REG09 (frequency 3)
This register defines the frequency channel to be used for radio communication. The frequency channel
that is set by this register is applied only if the RGE06 setting is 03H.
The range of the setting is 2,402 MHz to 2,481 MHz. It is possible to set it by both 2-digital hexadecimal
value (02H to 51H) and 3-digit decimal value (002 to 081). For more details of correspondence between
setting values and frequency channels, please refer section 5.1. FDP02 returns N0 response if the value is
out of the range.
REG10 (unused)
This register is not used. It should be default setting "01H".
REG11 (retransmission count)
This register defines the maximum frequency of data packet retransmission.
When the sender FDP02 cannot receive ACK signal from the receiver FDP02, it retransmits the data packet
"'defined value of this register' +1" times.
At broadcast transmission mode, the sender FDP02 always sends the data packet "'defined value of this
register' +1" times.
The enable setting range of this register is 00H to FFH (0 to 255 times). FDP02 returns N0 response if the
value is out of the range.
REG12 (unused)
This register is not used. It should be default setting "00H".
18
[Default: 51H]
[Default: 01H]
[Default: 0AH]
[Default: 00H]