FUTABA FDP02TJ010 Instruction Manual page 49

PTE (
Show/Set extended stand-by time
[Format]
PTE(:setting value)
Available setting value: 000 to 015
[Response]
xxx: Current setting value (as referring the value)
P0: Normal end (as setting the value)
N0: Co mmand error
[Function]
- This command can refer and/or set the time duration of the extended stand-by time. The extended
stand-by time duration is the setting value of this command times 20ms. For example, if the setting
value is 010, the extended stand-by time duration is 200ms (010 x 20ms). If the setting value is 000, the
extended stand-by time is not available.
[Example of use]
>@PTE<Cr><Lf>:
<003<Cr>Lf>:
>@PTE015<Cr><Lf>:
<P0<Cr><Lf> :
PTN (
Show/Set stand-by time
[Format]
PTN(:setting value)
Available setting value: 001 to 255
[Response]
xxx: Current setting value (as referring the value)
P0: Normal end (as setting the value)
N0: Co mmand error
[Function]
- This command can refer and/or set the time duration of the stand-by time. During the stand-by time, the
RF circuit is turned on. The stand-by time duration is the setting value of this command times 10ms.
For instance, if the setting value is 010, the extended stand-by time duration is 100ms (010 x 10ms).
[Example of use]
>@PTN<Cr><Lf>:
<003<Cr>Lf>:
>@PTN007<Cr><Lf>:
<P0<Cr><Lf> :
)
Show current setting value
The setting value is 003. It means that the extended stand-by time duration is
60ms (003 x 20ms).
Set the extended stand-by time duration to 300ms (015 x 20ms).
Normal end.
If the data packet is sent by broadcasting mode and/or the address
check function (REG18) setting is "
reception", the FDP02 does not turn to the "Extended Stand-by mode" even if
the extended time duration is set.
)
Show current setting value
The setting value is 005. It means that the stand-by time duration is 50ms (005
x 10ms).
Set the extended stand-by time duration to 70ms (007 x 10ms).
Normal end.
Disabling group address check at
37
Ver.1.1