Drive Motors; Removal; Installation - Upright TM12 Service Manual

Drive Motors

2-8 D M
RIVE
R
E M O V A L
1. Use a 1000 Kg (1 ton) capacity jack to raise the front of the machine. Position blocks under the
machine to prevent it from falling if the jack fails.
2. Block the rear wheels to prevent the machine from rolling.
3. Remove the cotter pin, nut, and washer.
4. Remove the wheel.
NOTE: Before disconnecting hoses, thoroughly clean off all outside dirt around fittings. (After disconnecting hoses and
before removing from vehicle, IMMEDIATELY plug port holes.)
5. Tag, disconnect and plug the hose assemblies to prevent foreign material from entering.
6. Support the drive motor/wheel yoke assembly and remove the retaining ring at the top of the wheel
yoke pivot. Remove the drive motor/wheel assembly from the machine.
7. Remove the locknuts, flat washers, capscrews and drive motor from the wheel yoke.
I
N S T A L L A T I O N
1. Position the drive motor in the wheel
yoke and secure with capscrews, flat
washers and locknuts.
2. Install the drive motor/wheel yoke
assembly into the pivot bearing along
with the lower thrust washer, thrust
bushing, and retaining ring.
3. Align the steer pin with the hole in the
steering link.
4. Remove the plugs from the hose assem-
blies and connect to the drive motor.
5. Install the shaft key, wheel, washer and
slotted nut. Torque the locknut to
102 N-m (75 ft. lbs.). Install a new cotter
pin. DO NOT back-off the nut to install
the cotter pin.
6. Remove the blocks, lower and remove
the jack.
7. Operate the drive system and check for leaks.
Page 2-18
OTORS
Section 2 - Service and Repair
Figure 2-15: Drive Motor Assembly
1. Drive Motor
2. Wheel Yoke
3. Steering Link
4. Bearing
5. Steer Pin
6. Retaining Pin
7. Thrust Bushing
8. Thrust Washer
107099-002 TM12 Work Platform