Table of Contents
Advertisement
Job Flow Function Keys
Thermal Growth
Use the Thermal Growth key to define the type of Thermal Growth for the current
job. The choices are: No Thermal Growth (default), At Feet, At Profile, Gap/
Offset, Face/Rim, and Reverse Dial. Refer to the Entering Thermal Growth Infor-
mation section on page 3-56 for more information.
Foot Pre-Check
Use the Foot Pre-Check key to define the type of Foot Pre-Check to be performed
on the current job. The choices are: No Foot Pre-Check (default), Soft Foot, and
Frame Distortion Index. Refer to the Foot Pre-Check section on page 3-76 for
more information.
Live Move
Use the Live Move key to define whether a live move can be accomplished in the
vertical direction. When selected, Live Move toggles between Horizontal Only
(default) and Vertical and Horizontal. When Horizontal Only is selected, the Live
Move option is not active on the Vertical Move screen. On the Dual Move screen,
the live move can only be performed in the horizontal direction. Refer to the Move
Machine section on page 3-129 for more information.
Enable Alert
Use the Enable Alert key to enable or disable (default) the live move audible tone
and flashing LED option during a live move. When the Enable Alert option is
enabled, the analyzer LED will flash when the machine alignment condition
reaches the target tolerance values. Increasing and decreasing flashes indicate
when the machine alignment crosses through the acceptable and excellent toler-
ance condition thresholds described above. The number of flashes and flash rate
will be consistent with the audible tone generated when the machine alignment
condition reaches the target tolerance values.
Laser Address Selection
Note
All machine dimensions are required for thermal growth inputs to be
taken into account; therefore, if a machine has been configured as a
"Fixed" machine this key is not available.
3-43
Advertisement
Table of Contents
