How To Select A Color Palette - Furuno FMD-3100 Operator's Manual

1. INTRODUCTION
1.6

How to Select a Color Palette

The system provides six sets of preset color and brilliance combinations to match any
ambient lighting condition. The specifications of each set are as shown in the table be-
low.
Palette
Day-gray
Day-blue
Dusk-gray
Dusk-blue
Night-gray
Night-blue
* Nominal brilliance values. Actual value may vary.
To select a palette, do the following:
1. Click the [Palette] button on the InstantAccess bar™.
[Palette]
button
2. Select [Day], [Dusk] or [Night] as appropriate. For example, select [Day] to show
its options.
3. Click the palette desired.
Note 1: A palette can also be selected by pushing the BRILL control on the Control
Unit.
Note 2: If the display cannot be seen when switching from a Night to Day palette, push
and hold the right button (approx. 2 seconds) to switch to the dusk-gray mode.
Note 3: The color palette setting may not get synchronized among ECDIS units se-
lected for synchronization if a unit is being booted during the selection of the color pal-
ette. If this occurs, wait until all ECDIS units selected for synchronization have booted
then reselect required color palette.
1-4
Brilliance (%)*
97
97
68
68
49
49
Log
Text color Background color
White
White
Light gray
Light gray
Orange
Light gray
Gray
Blue
Dark gray
Dark blue
Dark gray
Dark blue