Troubleshooting; C-Map Dynamic Licensing (Dl) Service; Chart Display; Introduction - Furuno FMD-3100 Operator's Manual

7. C-MAP BY JEPESSEN CHARTS
7.4

Troubleshooting

If you are having problems installing your software or charts please check the follow-
ing before contacting C-MAP:
• Check that the charts are available, with the chart management function.
• Check that the license is correctly installed, with the license function
Contact Information: For information please call you're nearest C-MAP Office (de-
tails can be found on the reverse side of the C-MAP chart CO box) or contact C-MAP.
E-mail: technical.marine@c-map.com
7.5

C-MAP Dynamic Licensing (DL) service

The C-MAP DL service is an ENC service available on DVD or online, in C-MAP SENC
format. The C-MAP DL ensures immediate access to ENC licenses whenever they are
needed. ENC licenses available in seconds automatically via online C-MAP service
providers. Cost is controlled via pre-set budgets and spending limits, giving shipown-
ers a true "pay-as-you-go" service. For further details about C-MAP DL, contact a C-
MAP provider.
Note: PC and internet connection with e-mail are required to use the C-MAP DL ser-
vice. Further it is necessary to access C-MAP approx. once every two weeks.
7.6

Chart Display

7.6.1

Introduction

The two type of C-MAP charts can be displayed together. These charts have the pri-
ority order shown below.
1) C-MAP ENC
2) C-MAP PROFESSIONAL+
If the same navigational purpose charts are available over an area, priority is as shown
above. Areas where ENC is not available C-MAP ENC charts are shown. Where C-
MAP PROFESSIONAL+ are available, C-MAP PROFESSIONAL+ charts are dis-
played.
The [Chart Legend] dialog box provides various information about the C-MAP chart
currently displayed. The information can be displayed two ways:
• For current position: Click the [TM/CU Reset] button while in the Voyage navigation
mode then click the [Chart INFO] button on the InstantAccess bar™ followed by the
[Chart Legend] button.
• For a specific location: Put the cursor on the location then right-click and select
[Chart Legend] . Click the [Close] button to close the display.
To close the dialog box, click the [Close] button.
7-2