ABB SPAC 536 C User Manual page 88

10
h)
The switch position is altered to the desired
position 1 by pressing the STEP push button
once.
i)
Using the same procedure the switches SGF 1/
4...8 are called up and, according to the exam-
ple, left in position 0.
j)
In the final setting mode position, correspond-
ing to step c), the checksum based on the set
switch positions is shown.
k)
If the correct checksum has been obtained, it is
recorded in the memory by pressing the push
buttons PROGRAM and STEP simultaneously.
At the moment the information enters the
memory, the green dashes flash in the display,
i.e.1 - - -. If the checksum is incorrect, the
setting of the separate switches is repeated using
the PROGRAM and STEP push buttons start-
ing from step d).
l)
Recording the new value automatically initiates
a return from the setting mode to the normal
menu. Without recording one can leave the
setting mode any time by pressing the PRO-
GRAM push button for about five seconds,
until the green display digits stop flashing.
m)
After recording the desired values return to the
main menu is obtained by pressing the STEP
push button until the first digit is turned off.
The LED indicator SGF still shows that one is
in the SGF position and that the display shows
the new checksum for SGF1 currently in use by
the relay module.
RESET
STEP
1 x
1 3
PROGRAM
5 x 1 s
1 0 0 5
RESET
STEP
1 - - -
PROGRAM
PROGRAM
5 s
1 0 0 5
RESET
STEP
n x 1 s
1
0 0 5