Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GRAUPNER GR-12SC+
Summary of Contents for GRAUPNER GR-12SC+
- Page 1 Manual GR-12SH+ and GR-12SC+ 6 channel 2.4 GHz HoTT receiver No. 33565 No. 33566...
-
Page 2: Table Of Contents
Index Introduction ..................4 Service centre ...................4 Intended use ..................5 Target group ..................5 Package content ................5 Technical data ...................6 Accessories ..................6 Connection table ................6 Symbol description ................7 Safety notes ..................7 For your safety by handling the transmitter and the receiver ..8 For your safety by handling the batteries ........9 Installation... -
Page 3: Introduction
Introduction Intended use Thank you very much for purchasing a Graupner 33565 GR-12SH+ The receivers GR-12SH+ and GR-12SC+ HoTT may only be used for or 33566 GR-12SC+ receiver. the purpose intended by the manufacturer, for the operation of slowflyer models whose components are equipped with SH or SC Read this manual carefully to achieve the best results with your HoTT plugs. -
Page 4: Technical Data
• Only use the components and spare parts that we recommend. Instead of a servo or motor controller connected to port "1", "Chan- Always use matching, original Graupner plug-in connections of nel 1" can be used as an electronic speed controller via the solder the same design and material. -
Page 5: For Your Safety By Handling The Transmitter And The Receiver
• Before you start using the remote control model, you have to For your safety by handling the batteries check the further relevant laws and regulations. These laws you must obey in every case. Pay attention to the possibly different CAUTION laws of the countries. -
Page 6: Installation
Installation Power supply The receiver must be protected against dust, exhaust gases, splash In principle, a battery can be connected to any free socket. By V- or water, etc. in the model. When you install your receiver, make sure Y-cable also with any remote control component. If the power sup- that it is not excessively airtight to prevent it from overheating during ply is provided by more than one battery, it is important to ensure operation. -
Page 7: Binding
Binding Setting and display of the receiver settings To establish a connection with the transmitter, the Graupner HoTT The receiver-side menus can be viewed and sometimes changed TELEMETRY receiver must first be "bound" to at least one model memory in "its"... -
Page 8: Display "Free Mixer
Port "6" is suitable for operating a servo or comparable RC com- Display "Free mixer" ponents. Up to five mixers can be programmed in the receiver. RX FREE MIXER • "Yes" MIXER: FROM CHANNEL: MIXER If the value field of this line has been set to "yes" and the relevant TO CHANNEL: TRIM: receiver is subsequently put into operation again, it generates a... -
Page 9: Firmware Update
The plug should be fully inserted. The programs and files required for updates can be found in the Download area for the corresponding products at www.graupner.de. The update takes place via the program part "Slowflyer / Gyro Receiver Downloads" of the program "Firmware_Upgrade_gr_Stu- dio"... -
Page 10: Simplified Declaration Of Conformity
These operating instruction are exclusively for information purposes and are subject to change without prior notification. The current version can be found on the Internet at www.graupner.de on the relevant product page. In addition, the company Graupner/SJ has no responsibility or liability for any errors or inaccuracies that may appear in construction or operation manuals.