Records; Transducer Inputs/Outputs; Fault Reports - GE C60 Instruction Manual

RECORDS

6.4.10 Transducer inputs/outputs

ACTUAL VALUES  METERING  TRANSDUCER I/O DCMA INPUTS  DCMA INPUT xx
 DCMA INPUT xx

Actual values for each DCmA input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value followed by the programmed units.
ACTUAL VALUES  METERING  TRANSDUCER I/O RTD INPUTS  RTD INPUT xx
 RTD INPUT xx

Actual values for each RTD input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value.
6.5 Records

6.5.1 Fault reports

ACTUAL VALUES  RECORDS  FAULT REPORTS  FAULT REPORT 1(15)
NO FAULTS TO REPORT
or
 FAULT REPORT 1

6
The latest 15 fault reports can be stored. The most recent fault location calculation (when applicable) is displayed in this
menu, along with the date and time stamp of the event which triggered the calculation. See the
SETUP  FAULT REPORTS
menu for manual clearing of the fault reports and to the
RECORDS
menu for automated clearing of the fault reports.
Where VA, VB, VC are phase voltage phasors in secondary volts; IA, IB, IC are current phasors in secondary amps, I0 is the
zero sequence current phasors in secondary amps; and IG is the ground current from the parallel line scaled to the source
phase CT in secondary amps. Z0/Z1 is the zero sequence impedance to positive sequence impedance ratio, and Z0M/Z1 is
mutual zero sequence impedance to positive sequence impedance ratio.
VTs of the
FAULT REPORT 1 SOURCE
connected VT to display the loop impedance and fault resistance for single phase-to-ground faults.
6-24
DCMA INPUT xx

0.000 mA
RTD INPUT xx

-50 °C
FAULT 1

LINE ID: SRC 1
FAULT 1 DATE:

2000/08/11
FAULT 1 TIME:

00:00:00.000000
FAULT 1 TYPE:

ABG
FAULT 1 LOCATION

00.0 km
FAULT 1 RECLOSE

SHOT: 0
menu for assigning the source and trigger for fault calculations. See the
must be connected in Wye or
Range: SRC 1, SRC 2, SRC 3, SRC 4
Range: YYYY/MM/DD
Range: HH:MM:SS.ssssss
Range: not available if the source VTs are in the
"Delta" configuration
Range: not available if the source VTs are in the
"Delta" configuration
Range: where applicable
SETTINGS  PRODUCT SETUP  CLEAR RELAY RECORDS
must be set correctly for the Delta
VT SUBSTITUTION
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES
SETTINGS  PRODUCT
COMMANDS  CLEAR