GE C60 Instruction Manual page 101

CHAPTER 3: INSTALLATION
6. Replace the top cover and the cover screw.
7. Re-insert the C37.94SM module. Take care to ensure that the correct module type is inserted into the correct slot
position. The ejector/inserter clips located at the top and at the bottom of each module must be in the disengaged
position as the module is inserted smoothly into the slot. Once the clips have cleared the raised edge of the chassis,
engage the clips simultaneously. When the clips have locked into position, the module is inserted fully.
Modules shipped since January 2012 have status LEDs that indicate the status of the DIP switches, as shown in the
following figure.
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 3-59: C37.94SM timing selection switch setting
DIRECT INPUT AND OUTPUT COMMUNICATIONS
3
3-51