Installing The Process Adapter Into The Measuring Pipe; Connection To The Small Flange Adapter; G1", G3/4" Threaded Joints; G1/2", G3/8" Threaded Joints - ABB FMT200-ECO2 Operating Instruction

4.4 Installing the process adapter into the measuring pipe

Important
The variable process adapters are attached to the pipe with a fine internal threading. This connection can
be carefully unscrewed, using a spanner SW 30. Before refitting, clean and lightly grease the process
adapter threading. Make sure the O-ring is mounted properly.
4.4.1
4.4.2
4.4.3
Both adapters are equipped with a High-Tec flow conditioner sieve on the inflow side. Because of it, no
steadying lengths are required.
10 Thermal Mass Flowmeter FMT200-ECO2

Connection to the small flange adapter

G1", G3/4" threaded joints

G1/2", G3/8" threaded joints

Installation and start-up
30
30
30
30
42/14-41 EN