Insert the other disks if you see this message:
Fig. 6-3
6.2 Starting the configuration program
Start the program ECO2.EXE in the directory you have selected.
6.2.1
Fig. 6-5
6.2.2
Select the command → „configure" within the configuration menu.
Fig. 6-6
If the connection is successfully established, you will see the first page of the configuration program.
42/14-41 EN
Thermal Mass Flowmeter FMT200-ECO2
Changing the language
Establishing the connection
Fig. 6-4
Select the menu item "Sprache wählen"
inside the menu Konfiguration.
Choose a flag symbol.
After that, the program will switch to En-
glish or French language.
Select the serial interface (Default = Com1) and the printer port you
are using.
After clicking ok, the program will test the connection.
If any problem occurs, you will see the following message
Fig. 6-7
In this case, check if you have selected the correct interface, Are all
cables connected ?
Is the FMT200-ECO2 (Sensyflow eco2) in operation (green light)?
Changing the configuration
15