Perfonning An Analysis - Micromeritics AccuPyc 1330 Quick Reference Manual

GENERAL OPERATING INSTRUCTIONS AccuPyc 1330
PERFORMING AN ANALYSIS
Press LI
_-,I
V/lN;1
to perform an analysis.
Display
4-6
Entry
This prompt is displayed only when Sampie ID was en-
abled in the Set-Up function (refer to Report Options later
in this chapter).
The sampie ID can contain from 1 to 20 numbers and
dashes.
Enter the sampie ID and press Ill\lttilitl.
NOTE
Press
I tIW M
to insert a dash.
This prompt is displayed only if density was selected for
Analysis display mode (refer to Report Options later in
this chapter.)
Enter the sampie weight and press li!iir!!~ : J .
Range:
000.0000 to 999.9999 g
Choose ODe of the following:
• Press 1l!i'lfElIl to start the analysis.
The analysis begins and operational status messages are
continually displayed .
• Press
1 ' · ! iÄVi\' d
to store the data you ente red and return to
display mode.
• Press LI _-,l lt tUIl. l to cancel the
analysis.
22
Aug 90
•