Micromeritics AccuPyc 1330 Quick Reference Manual page 4

PERFORMING AN ANALYSIS - - - - - - - - - - - - - - - -
1. Weigh the empty sampie cup and record the weight
2. Place sampie in the cup and dry it thoroughly in an oven.
3. After preparing the sampie. weigh the cup and sampie and record the weight. Subtract
the empty sampie cup weight from the sampie cup plus sampie weight to determine the
sampie weight Record the sampie weight.
4. Remove the cell chamber cap.
5.
Insert the sampie cup into the cell chamber and replace the cell chamber cap.
6.
Press
L I _-----' I
[ @liNnonthepycnometerkeypad.
7. If Sampie ID is displayed. enter the ID and press
lEl'tltill.
If not, skip to step 8.
8.
If Sampie Weight is displayed. enter the weight and press
l'Ii!rtli'~I.
If not. skip to step
9.
9. Press
I El'tltä I
to start the analysis.
10.
As the analysis is perforrned. status messages
are
displayed. When the analysis is com-
plete. the pycnometer beeps three times. Remove the sampie from the cell chamber.
11. The Reload prompt is displayed. Press
tooolOEI
to cycle through the error messages and
repon
data.
CHANGING THE OPERATING LANGUAGE - - - - - - - - - - - - -
1. If an automatie operation is in progress. wait until it is complete.
2. Press
L I
_---'lljjwill
to return to display mode if you
are
in another mode of operation.
3.
Press
L.I _-,lllmä :;nI.
4.
Press
ICHOlCEI
until Unit type? is displayed.
5. Press
I mll~1
until Language? is displayed.
6.
Press
I~I
until the desired language is displayed. Then press
1: ~AYl!) I.
Part No. 133-429()3.()()