Setting Up Recognition Mode; Two Attempts Mode; Parameters - Sagem Securite MorphoAccess J-Bio User Manual

M A ® J S – User Guide
ORPHO CCESS ERIES

1. Setting up recognition mode

Two attempts mode

Parameters

DOCUMENT SSE-0000077399-01 - V
S S D
AGEM ÉCURITÉ OCUMENT
If the recognition fails, it is possible to give a "second chance" to the user.
In identification mode, if a bad finger is presented, the user has 5 seconds to
present a finger again. The result is sent if this period expires or if the user
presents a finger again.
In authentication mode, if the user presents a bad finger, he can replace his
finger without presenting his card again. The result is sent only after this
second attempt.
It is possible to set the finger presentation timeout and to deactivate this "two
attempts mode".
If the user is not identified, a second step follows immediately using a smarter
coding method. This coding allows recognizing users with dry fingers or
fingers with a bad placement on the sensor. However this coding is slower than
the light one.
This mode can be configured using the Configuration Tool for example.
By default, the two attempts mode is activated.
Setting up the number of attempts
app/bio ctrl/nb attempts
The period between two attempts in identification (two attempts mode) can be
modified.
Setting up the identification timeout
app/bio ctrl/identification timeout
1.0 - M
ERSION AY
- R D
EPRODUCTION AND ISCLOSURE
Setting up recognition mode
2010
P
ROHIBITED
1 (only one attempt)
2 (two attempts mode)
5 (1-60)
61