Safety Instructions; Europe Information; Usa Information - Sagem Securite MorphoAccess J-Bio User Manual

Safety instructions

2. Safety instructions

Europe information

USA information

4
The installation of this product should be made by a qualified service Person
and should comply with all local regulations.
It is strongly recommended to use a class II power supply at 12V ±5% and
0.5A. min (1A with Wi-Fi
Voltage (SELV). The 12V power supply cable length should not exceed 5
meters.
This product is intended to be installed with a power supply complying with
EN60950, in accordance with the NEC Class 2 requirements; or supplied by a
listed EN60950 external Power Unit marked Class 2, Limited Power source, or
LPS and rated 12VDC, 0.5A minimum (1A with Wi-Fi
In case of building-to-building connection it is recommended to connect 0V to
ground. Ground cable must be connected with the terminal block 0V GND.
Sagem Sécurité hereby declares that the MorphoAccess
been tested and found compliant with following listed standards: EN302 291-
2 V.1.1.1 (2005-07) + recommendation 1999/519/CE with standard EN 50364;
EN 301 489-3 V.1.4.1 (02), and low voltage Directive 2006/95/CE: CEI60950-
1:2005 2nd edition.
Responsible Party: Sagem Sécurité, Le Ponant de Paris, 27, rue Leblanc -
75512 PARIS CEDEX 15 - FRANCE.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
DOCUMENT SSE-0000077399-01 - V
S S D
AGEM ÉCURITÉ
M A
ORPHO CCESS
TM
option) according with Safety Electrical Low
- R
OCUMENT EPRODUCTION AND
® J S – User Guide
ERIES
TM
option).
®
J Series terminal has
1.0 - M 2010
ERSION AY
D P
ISCLOSURE ROHIBITED