Access Control By Identification - Sagem Securite MorphoAccess J-Bio User Manual

M A ® J S – User Guide
ORPHO CCESS ERIES

1. Access control by identification

DOCUMENT SSE-0000077399-01 - V
S S D
AGEM ÉCURITÉ OCUMENT
Identification mode activation
app/bio ctrl/identification
To configure the MorphoAccess
identification to 1.
After start-up, the MorphoAccess
is lighted on.
The user places a finger on the sensor to start identification process.
If the identification is successful, the terminal triggers the relay or returns the
corresponding User ID to central security controller.
The user ID can be sent through various interfaces. Please refer to
®
MorphoAccess Remote Messages Specification for a complete description of
"hit" and "no hit" messages.
Result is returned to the user by a light and audible signal.
Once the user identification is done, the terminal automatically loops back and
waits for a new finger.
At least one user (biometric template) must be stored in the local database. The
reminal can store 500 users with 2 fingerprints each and 3,000 users with a MA
3K USERS licence.
If the terminal is running in identification mode with an empty database, the
sensor is off and the led flashes «yellow» (please refer to Convention Section).
1.0 - M
ERSION AY
- R D
EPRODUCTION AND ISCLOSURE
Access control by identification
®
in this mode, set the parameter app/bio ctrl/
®
waits for fingerprint detection. The sensor
2010
P
ROHIBITED
1
39