Access Control By Authentication - Sagem Securite MorphoAccess J-Bio User Manual

M A ® J S – User Guide
ORPHO CCESS ERIES

2. Access control by authentication

DOCUMENT SSE-0000077399-01 - V
S S D
AGEM ÉCURITÉ OCUMENT
This section only applies to MorphoAccess
® ®
MIFARE /DESFire contactless smartcard reader (see section Scope of the
document).
Whatever is the contacless smart card type, the contained data has the same
structure.
Various recognition modes can be applied depending on the user's fingerprint
templates localization, and the required security level.
Authentication modes can be combined with a local identification (multi-factor
mode).
Following modes are available:
Authentication with templates on contactless card:
Captured fingerprints are matched against templates read on the card (PK).
Identifier and fingerprints must be stored on the card. It is also possible to skip
the biometric control: in this case the terminal acts as a badge reader.
Authentication with template on local database and user ID on card:
Captured fingerprints are matched against templates stored in the user's record
stored in the local database. Only the identifier is required on the card. It is also
possible to skip the biometric control: in this case the terminal acts a badge
reader.
Authentication based on contactless card mode:
In that mode, the access rights check to perform is specified on the contactless
card. This indicator specifies either "fingerprint check enabled" or "fingerprint
check disabled.
Depending on the card mode either templates are read on the card or the control
can be bypassed (visitor mode). This mode is only compatible with contactless
card with the "card mode" tag, and the corresponding data (user's fingerprints)
must be stored on the card.
Please refer to MorphoAccess
description of card structure and access mode.
1.0 - M
ERSION AY
- R D
EPRODUCTION AND ISCLOSURE
Access control by authentication
®
J Series equipped with a
®
Contacless Card Specification for a complete
2010
P
ROHIBITED
45